The Valve Trim Kit includes: inlet valve, finish door, low voltage switch, 4 screws, 2 wire nuts, 1 silicone pack.
The Hide-a-Hose Wall Inlet Valve is needed in all hide-a-hose applications. It is where the hose enters and exits the vacuum piping. This model has a door that opens upwards, revealing your hose, the locking mechanism, and the on/off switch that operates your central vacuum.
The locking mechanism allows you to pull out however much hose you need and lock it in place. Releasing this lock and putting your hand over the hose causes the hose to quickly and conveniently recede back into the piping.
The switch simply acts as an on/off switch for your central vacuum. This is the most basic way to operate your vacuum via hide-a-hose. if you want to be able to operate your vacuum with your handle via hide-a-hose, you need an .
The is required for installing this valve into a wall. If you are going to be installing this valve using a , you do not need the Rough-in Kit.
Refer to the Hide-a-Hose Installation Guide PDF below for Valve Trim Kit installation instructions.